Cannular Bench Top Can Seamer
$549.99
The Cannular is a manual can seamer that is easy to use, reliable, and beautifully simple.
Whether you’re a brewery looking to offer canned beer to go or a homebrewer wanting to keep your creations fresh and fully protected from light, the Cannular is the answer. This bench top unit is one of the most compact and easy to use can seamers you’ll find. The Cannular only requires one person to operate, and each can takes roughly 5 seconds to seam. With a two-person team, one filling and one seaming, the Cannular becomes a suitable option for nano breweries doing small canning production runs.
The Cannular’s table spacer is specifically designed to work with 500ml (16.9 oz) Can Fresh aluminum cans. 330ml (11.2 oz) Can Fresh cans are also available, but you will need the correct table spacer to use them with the seamer. We have tested standard 202 cans and have been able to achieve good seals with proper adjustments. It is necessary to adjust the table height to ensure you have the appropriate amount of pressure applied when the can lift is raised.
Operation:
The beauty of the Cannular lies in how truly simple it is to operate. With only three points of operation, it only takes a few minutes to familiarize yourself with the machine. The seaming process is as follows:
Place lid atop the can and place the can on the table spacer
Turn the platform lever clockwise to raise the can to the seamer
Press the button to turn the machine on and begin spinning the can
Push the seaming lever away from you and hold for 1-2 seconds
Pull the seaming lever towards you and hold for 1-2 seconds
Press the button to turn off the machine and stop spinning the can
Turn the platform lever counterclockwise to lower the can
Out of stock
Description
Specifications:
Power: 250W
Rated Speed: 3300 RPM
Gearbox Ratio: 9.8 : 1
Dimensions: 14″ L x 9″ W x 19.5″ H
Weight: 40 lbs
*Please note: the table spacer included with the Cannular is specifically designed to use Can Fresh 500ml aluminum cans, which are 167.8mm tall and 52.4mm in diameter. See below under “You Might Also Need” for an additional table spacer that can be purchased to make the seamer compatible with 330ml cans.
**Note 2: When you receive your cannular the rollers have been set and tested at the factory. They should not need adjustment for 100,000 cans. The table, however, comes unadjusted and getting it set up correctly is very important to getting a proper seal. Cannular’s test show that a .4mm (.015″) actual overlap is all that is needed to seal to 90 PSI. The proper table tension takes a little practice and expect to waste a few cans getting it dialed in. Once you learn the proper tension re-adjusting it is very quick and easy. You want the tension to be tight but not so tight as to dent the can. Use cans at your fill height with water for proper tension adjustment.
